VTP – Vlan Trunking Protocol
Le VTP permet la gestion de la base de donnée des VLANs, 3 modes :
- Serveur
- Ajout de vlan
- Suppression de vlan
- Modification
- Propagation des informations
- gestion des VLAN de 1 à 1005
- Client
- Réception et propagation des informations
- Ajout / Suppression / Modification –> impossible
- Transparent
- Ajout de vlan
- Suppression de vlan
- Modification
- PAS de propagation des informations
- gestion du range étendu: VLAN 1006 à 4094
Configuration
SW1#conf t
SW1(config)#vtp mode ?
client Set the device to client mode.
server Set the device to server mode.
transparent Set the device to transparent mode.
SW1(config)#vtp mode server
SW1(config)#vtp domain TEST
SW1(config)#vtp password cisco
SW1(config)#vtp version 2
« vtp interface » permet de spécifier l’ID utilisé
SW1(config)#vtp interface lo0 only
Vérifications
SW1#show vtp status VTP Version : running VTP2 Configuration Revision : 0 Maximum VLANs supported locally : 1005 Number of existing VLANs : 10 VTP Operating Mode : Server VTP Domain Name : TEST VTP Pruning Mode : Enabled VTP V2 Mode : Enabled VTP Traps Generation : Disabled MD5 digest : 0x57 0xD8 0x57 0xD5 0x9B 0x6D 0xBE 0x60 Configuration last modified by 0.0.0.0 at 3-1-93 00:41:07 Local updater ID is 192.168.100.1 on interface Lo0 (preferred interface) Preferred interface name is lo0 (mandatory)